1. Prepare your skin for the Synergy Marble by cleansing the treated area thoroughly. 2. Dry the area thoroughly. 3. We recommend applying the Opatra Collagen Mask to the treated area. This is optional; however, the best results are achieved by applying a facial mask or serum whilst using the device. 4. Lift your Synergy Marble device from the docking station and switch the device ON by pressing down the control button for 2 seconds (large round button). The rim around the control button will light up. This will indicate the device is switched on. 5. Begin your session – depending on which mode you wish to use first. 6. The smart, hyper glide head will activate once in contact with the skin. Depending on the function selected – red and infrared mode, blue or yellow led light will automatically activate. 7. To switch to the RED LED LIGHT, press the control button down (1 second), and the Anti-Ageing 42°C will show on the device. 8. To switch from RED LED LIGHT to BLUE LIGHT LED in-between sessions – click the control button once. Cleanse – Detoxify 19°C will show on the device. 9. To switch from BLUE LED LIGHT to YELLOW LIGHT LED in-between sessions – click the control button once. Repair – Relax 19°C will show on the device. 10. Apply light pressure whilst slowly moving the Synergy Marble device upwards and outwards, from bottom to top. Circular motions are suggested only when cleansing. 11. Treat the desired area for 5 - 7 minutes on each side. 12. When you have completed the session, TURN OFF your device by pressing and holding down the control button for 2 seconds. The rim light around the control button will turn off. 13. It is recommended that after treatment, apply a small amount of moisturising cream onto the treated area after each session. 14. Your device will start beeping and a red flashing image will appear on the device, indicating your battery is low. Place your device into the docking station and charge for 3 hours.